Steel Type for Trailer Axle Spindle TRU44FR
Updated 11/29/2017 | Published 11/28/2017
Question:
Can you provide the material/type of steel used for spindle #TRU44FR?
asked by: Timm C
0
Expert Reply:
I checked with Trudyde, and I was able to find out that the bar stock material used to make the spindle is hot rolled SAE 1045 steel, which allows the spindle to harden to an extent. The spindle needs to retain a slight amount of flex to retain its durability when a trailer goes over a bump or through a hole in the road.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
BTR E-Z Lube Spindle for 2,000-lb Trailer Axles - 1-1/4" Diameter
- Trailer Spindles
- EZ Lube Spindle
- Without Flange
- L44649
- 1-1/4 Inch Diameter
- Round
- For 2000 lb Axle
- TruRyde
more information >
Continue Researching
- Search Results: 6 lug hub
- Search Results: 1/2" hitch pin
- Shop: Dexter Trailer Idler Hub Assembly for 5,200-lb E-Z Lube Axles - 6 on 5-1/2
- Shop: Easy Grease Trailer Idler Hub Assembly for 6K Axles - 6 on 5-1/2 - Pre-Greased
- Shop: Dexter Trailer Idler Hub Assembly for 6,000-lb Axles - 6 on 6 - Agricultural
- Shop: Easy Grease Trailer Idler Hub Assembly for 3.5K Axles - 6 on 5-1/2 - Pre-Greased
- Shop: Agricultural Trailer Hub Assembly for 7K Axles - 6 on 6 - Wheel Studs
- Shop: Trailer Idler Hub Assembly for 3,500-lb Axles - 6 on 5-1/2
- Q&A: What Grade Steel is Spindle # TRU74FR Made Of
- Q&A: What are Trailer Spindles Made Of
- Shop: BTR E-Z Lube Spindle for 2,000-lb Trailer Axles - 1-1/4" Diameter
- Search Results: tru44fr
- Q&A: Do Trailer Spindles Just Weld to End of Axle
- Q&A: How to Determine Between 5 on 4-1/2 and 5 on 5 Bolt Patterns for Hub Covers
- Search Results: trailer hub
- Search Results: trailer brakes
- Search Results: spindle
- Search Results: weld on spindle
- Q&A: Does Trailer Misalignment Cause Outside Tire Wear
- Video: All You Need to Know About the Dexter Brake Line Tee with Mounting Bracket
- Q&A: What Material are Trailer Spindles Made of
- Q&A: Does a Spindle with Scarring and Complete Bearing Failure Need to be Replaced