Backup Alarm Recommendation For 2010 Toyota Tacoma
Published 10/11/2017
Question:
can you tell me if Hopkins builds a tail light back up alarm for a 2010 Toyota tacoma txs
asked by: Jerry
0
Expert Reply:
The reverse light bulb type for the 2010 Toyota Tacoma is a 921 wedge type bulb. While there isn't a combination reverse light bulb and back up alarm in this size there are back up alarms available by themselves such as # PK41820.
You can mount one on the underside, rear of the vehicle and tap into a reverse light wire. I have also included a link to all of the back up alarms and sensors that we carry.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Light-Duty to Medium-Duty Back-Up Alarm with Wire Leads - 12-24 Volts - Less than 0.3 Amp - 97 dB
- Back Up Alarm
- Low Volume
- Steam-Cleanable
- Voltage Spike-Protected
- 97 Decibels
- Surface Mount
- 12V
- 24V
- Pollak
more information >
Continue Researching
- Q&A: Does the Bigfoot Hydraulic Jack Come with the Switches or Remote?
- Q&A: How Do Wires Connect to TowSmart ProClass 7-Blade Trailer Connector w/ Wire Tester
- Q&A: How do I Trickle Charge a Battery on my Trailer
- Q&A: Can Redarc In-Vehicle BCDC Trailer Battery Charger Charge Two 100 Amp-Hour Batteries
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Solar Panel for a Redarc In-Vehicle BCDC Trailer Battery Charger
- Q&A: Trailer Brakes Lock Up When Connected to Truck
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Testing Breakaway Systems