Level Recommendation for Top of Powered A-Frame Jack
Published 10/04/2017
Products Featured in This Question
Question:
DO YOU HAVE A REPLACEMENT CAP #EJ-3520-BCP THAT HAS A BUBBLE LEVEL?
asked by: Dana B
0
Expert Reply:
I have a much easier solution. What you'd want to do is install the Hopkins Never Fade Multipurpose Bubble Level # HM09516.
This will adhere to the top of your jack and will allow you to know when your trailer is sitting level.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- 1 Jack
- RAM
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Electric Tongue Jack For FIC 3500 A-Frame Trailer Tongue Jack With Cracked Case
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Wiring An Electric Trailer Tongue Jack Into 7-Way Vehicle Trailer Connector
- Q&A: Recommended Electric Trailer Jack For A 2018 Jayco Whitehawk
- Q&A: Simple Replacement Jack For a 2023 Casita 17' Travel Trailer With FIC Tongue Jack
- Q&A: Troubleshooting Electric Trailer Jack Not Working With Fully Charged Battery
- Q&A: How to Wire etrailer Electric Trailer Jack
- Q&A: How to Determine Weight Capacity of Electric Trailer Tongue Jack for Camper
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: Determining Trailer Tongue Weight
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)