Electric Waste Valve Compatibility to Replace Cable Actuated Valves

Question

Question:

Can a 3valterra electric valve be installed horizontally?can these valves replace existing valterra cable actuated valves?

asked by: John D

1

Helpful Expert Reply:

The Valterra EZ Valve Electric Waste Valve for RV Black Water Tank - 3" Hub to 3" Hub # E40B-8 can be installed horizontally as well as vertically without any issue. I reached out to my contact at Valterra to confirm and they absolutely can replace existing Valterra cable actuated valves. You will simply unbolt the hubs and make sure the seals are in place when you bolt the valve into your current setup. They did mention that the motor is slightly wider than the valve body, so you will need to make sure you have that space for install. I've attached a photo of the side view for you.

This kit comes with 8 feet of wire for your switch location.

expert reply by: Jason S

1

click to enlarge

Answer 1

Hey Nisha, The SeeLevel Bluetooth enabled tank monitor 709-BTP7 can be purchased under part #SE74RR. If you need anything else or have any questions just let me know and I'd be happy to help.

view full answer...

Answer 2

The difference between a hub connection and a spigot connection is that the hub is the female end and has a lip on the inside that stops the spigot (or male) end where it needs to be. I have attached some pictures to assist. With this knowledge it is…

view full answer...

Answer 3

The difference is between just the MORryde Locking RV Storage Box #MR43RR and when you add the brackets at their widest setting. Just the box measures 25-3/4" but when you add the mounting brackets is when you'll see that 27-3/4" width…

view full answer...

Answer 4

Hey Mark - I checked directly with Thule on that one. The Epos 3 bike rack for 2" hitches #TH34FR44SR isn’t approved for RV or flat-towed applications; it’s for standard passenger vehicles only. That’s due to the extra bounce at the back of a…

view full answer...

Answer 5

Hey Vince, the Valterra E-Valve Electric Waste Valve System for RV Black and Gray Water Tanks #VAL95MB does need to connect to a 12 volt power source so you could run it to your batteries directly if that's an option?

view full answer...

Answer 6

Hey Larry, Yes, The Valterra #VAL95MB is a kit with both the #VAL35MB 3" and #VAL55MB 1-1/2" included. They kit them together for a convenient full replacement system, or we offer them both separately as well. Are you looking to get both…

view full answer...

Answer 7

Tom, unfortunately the controller 2020003067 is not going to work in place of the 289252, so It would need to be replaced with the 289252. I have also confirmed this with Lippert to make sure.

view full answer...

Answer 8

Typically, with built-in microwaves like the Greystone Standard RV Microwave w/ Trim Kit #324-000106, the 110v plug should be routed to an outlet inside a nearby cabinet. If your microwave isn't heating up, you may have a burnt out diode or the…

view full answer...

Answer 9

Hi William; I'm really sorry to hear that happened. Unfortunately, RV fireplace manufacturers like Greystone don't offer replacement parts. I know it isn't ideal, but the only real solution here is to completely replace it with a new one.…

view full answer...

Answer 10

The MORryde StepAbove entry steps install inside your camper's doorframe, measure between the door frame flanges to determine your doorway width. The doorway threshold will be used as the mounting point, measure from the mounting point to the…

view full answer...

Electric Waste Valve Compatibility to Replace Cable Actuated Valves

Product Page this Question was Asked From

Continue Researching