Installation Instructions for the Ventline Powered Vanair Trailer Roof Vent # VP-543SP

Updated 09/05/2017 | Published 09/01/2017

Products Featured in This Question

Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke

(285)

$89.96

16-14 Gauge Butt Connector - 5 Pack

(33)

$4.23

Roof Vent Installation Kit - Sealant, Butyl Tape, Screws - White

(424)

$62.96

16 Gauge Primary Wire - White - Per Foot

(64)

$0.76

Ring Terminal -16-14 Gauge - 1/4" Ring ID - Qty. 1

(76)

$1.22

Question:

Ventline Powered Vanair Trailer Roof Vent # VP-543SP Does this vent come with installation instructions? Im a girl that needs a little guidance to install this.

asked by: Gina

Expert Reply:

The installation instructions for the Ventline Vanair Trailer Roof Vent # VP-543SP that you referenced are included in the box and are as follows:

1.Cut a 6-1/4" diameter rough opening through roof. (You can use the smaller diameter of the ceiling garnish as a template.)
2.Remove the two screws from the roof cap and then take off the cap for access to the mounting holes.
3.Apply sealant to bottom of flange. Be sure to surround each screw hole.
4.Make electrical connections.
5.Insert vent into the rough opening and align it correctly with the trailer. The flange is stamped "FRONT" on the part that should be oriented toward the front of the trailer or RV.
6.Mount to roof with #8 screws.
7.Insert ceiling garnish into opening and attach with #8 screws.

You will need the Installation Kit # 344270KITW for the sealant and #8 screws.

Please note that it should not be used above tubs, showers, or range cooking surfaces.

You may also need 16 Gauge Wire # DW02359-1, a Ring Terminal # DW05702-1 for the Ground, and Butt Connectors # 05731-5 to complete the installation if you don't already have them.

I have attached a review video for you to check out as well.