Does Paddle Handle Latch # PLR5115 Come with Inside Release Knob

Question

Question:

PLR5115 does this latch also come with th release latch on the inside?

asked by: Tess J

0

Expert Reply:

Yes, the Paddle Handle Latch # PLR5115 does come with the release knob that you seen in the picture for the interior of the door.

expert reply by: Jameson C

0

click to enlarge

Answer 1

We do not have a direct replacement for the size latch you have on your trailer. The Paddle Handle Locking Latch w/ Release - 5-1/2" Long x 4-1/4" Wide - Steel #PLR5115 for a 4-5/8" long x 3-3/8" cutout is the largest latch we…

view full answer...

Answer 2

I spoke with a contact at Atwood. The main concern for the GS961LP is ensuring that it receives 12V power. Because the Atwood LP Gas Detector RV 12V White 36719 has this, it's highly possible that it can work for you. However, we do not sell this…

view full answer...

Answer 3

We have exactly what you are looking for. You will want the Atwood combination gas and carbon monoxide detector #AT36681.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Does Paddle Handle Latch # PLR5115 Come with Inside Release Knob

Product Page this Question was Asked From

Continue Researching