What is the Width of the Square Mount of the Bulldog Replacement Pipe Mount # BD500339
Updated 07/31/2017 | Published 07/28/2017
Question:
Can you tell me what the inner diameter of the square piece is? I have an 8k bulldog jack that I would like to make into a swivel jack . Thanks
asked by: Wyatt W
1
Helpful Expert Reply:
On the Bulldog Replacement Pipe Mount for Swivel Jack - Weld On - 5/8" Pull Pin, # BD500339, the square mount measures 2-1/4 inches wide.
expert reply by:
Jared P
1
Product Page this Question was Asked From
Bulldog Replacement Pipe Mount for Swivel Jack - Weld On - 5/8" Pull Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pipe Mounts
- Bulldog
more information >
Continue Researching
- Q&A: Distance From Hitch Pin Center to Beginning of Drop on Draw Tite Ball Mount 40332
- Q&A: Switch Wiring Diagram for Solera Power Awning Switch Kit # LC285500
- Q&A: Replacement Rubber Plug For Ultra-Fab Trailer Jack UF38-944014
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Q&A: Brake Controller Installation on 2011 Toyota Tundra
- Q&A: Parts Needed and Instructions for Installing Brake Controller on a 2019 Jeep Wrangler Unlimited
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Ram Trailer Tow Prep Package
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Couplers
- Article: Trailer Lighting Requirements
- Article: Determining Trailer Tongue Weight
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)