Can Camco Horizontal 2-Stage Propane Regulator CAM59333 be Used with 100 Pound Propane Tank

Question

Question:

will this reg. lower the pressure from a 100lb cyl. so my trailer reg works normal?

asked by: Steve

0

Expert Reply:

Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr Item # CAM59333 will maintain a constant 11 inch water column of pressure. It can be used with other regulators as long as they are rated the same. The Camco regulator has the P.O.L. fitting which is used on 100 pound propane tanks like yours.

expert reply by: Michael H

0

Answer 1

Those three regulators are all very similar and essentially do the same thing but they're used on different propane setups. Part #37207-30365 is a vertical regulator. Vertical regulators are commonly on propane systems on travel trailers or pop…

view full answer...

Answer 2

The RockyMounts HighNoon FC Bike Rack #RKY67RR is a good option but there can be limitations. If your fenders come down too far on the tire you still won't be able to mount it properly. I prefer the Hollywood Racks RV Rider Bike Rack for 2…

view full answer...

Answer 3

The difference between the prices of the JR Products Automatic Changeover LP Gas Regulators and Camco Automatic Changeover 2-Stage Propane Regulators are in the BTU per hour, which as you correctly noted, is important information. The JR Products…

view full answer...

Answer 4

Hey Mark, To plug the unused ports on your JR Products RV LP Gas Manifold #JR65CR you'll just need the JR Products RV LP Gas Manifold Plug #JR25CR. We also offer a couple of adapters to make your connection to the ports easier: 1/2" x…

view full answer...

Answer 5

Hello Royer, Thanks for writing in, we’re glad you found us! The correct wiring harness for your 2020 Toyota Highlander XLE without the factory tow package is the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C76CR. Even…

view full answer...

Answer 6

For your propane tank with fill valve, you most likely need the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr #CAM59333. This will have the 1/4 inch NPt inlet and the 3/8 NPT outlet and will maintain a constant 11 inch water…

view full answer...

Answer 7

Hey Kevin, to replace your Marshall 290-1 regulator you can use the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L #CAM59333 or you can use the #CAM59313 for a vertical regulator replacement. Both of these regulators are 2 stage, rated for…

view full answer...

Answer 8

Hey Mark, thanks for reaching out! The Camco Horizontal 2-Stage Propane Regulator #CAM59333 is exactly what you need for your 100 lb propane tank because it has the POL connection on the end as opposed to a Type 1 connector used for a 30 lb tank. The…

view full answer...

Answer 9

For your 100 lb propane tank and 30,000 btu ventless heater you should use the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L #CAM59333 to maintain constant pressure. The inlet on this regulator is a 1/4" NPT connector and the outlet is a…

view full answer...

Answer 10

Though your heater unit has a built-in regulator, it is only capable of handling a very narrow flow rate range. For this reason, it's best to not consider an appliance's built-regulator as a replacement for the second stage for a two-stage…

view full answer...

Answer 11

Thanks for the picture! To replace your Marshal 605H propane regulator you will need to go with the Camco Vertical 2-Stage Propane Regulator #CAM59313. This will be an exact replacement for your current regulator. I included a video review of the…

view full answer...

Can Camco Horizontal 2-Stage Propane Regulator CAM59333 be Used with 100 Pound Propane Tank

Product Page this Question was Asked From

Continue Researching