What is the Jack Screw Size and Thread Pitch on the Ultra-Fab Stackable Stabilizers
Updated 06/16/2017 | Published 06/14/2017
Question:
Could you tell me what the thread pitch/size is for this screw jackstand. Thanks
asked by: Richard J
0
Expert Reply:
The Ultra-Fab Stackable Stabilizers, # UF48-979003, jack screw measures 3/4 of an inch and has a thread pitch of 12 thread per inch.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Ultra-Fab Stackable Stabilizers for Small Trailers and Campers - 6,000 lbs - Qty 2
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- Stabilizer Jacks
- Aluminum
- 5001 - 6000 lbs
- Manual Jack
- 17 Inch Lift
- 2 Jacks
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Which RapidRamps Bolt On Trailer Ramp Kit Is Best For My Car Hauler Trailer?
- Q&A: Can Aluminum Trailers Ramps In RapidRamps Kit Be Adjusted For Different Width Vehicles?
- Q&A: Adjustable Width Trailer Ramps For Loading Equipment With Different Tire Widths
- Q&A: Looking To Replace Dometic Duo Therm 991721729 AC Unit
- Q&A: Recommended Stabilizer Jacks for a Rpod Trailer
- Q&A: Can B and W Gooseneck Hitch Ball # BWGNXA2061 be Used with Andersen Ranch Hitch
- Q&A: Replacement Oil Seal for AL-KO 568303
- Article: Determining Trailer Tongue Weight
- Article: Trailer Tire Sizing
- Article: How to Measure for Trailer Hitch Drop
- Article: Best Bike Racks for Electric Bikes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Jacks