What are the Dimensions of the Replacement Drop Leg with Foot on # TJD-7000-FT
Updated 06/15/2017 | Published 06/14/2017
Question:
Will the TJD-7000-FT jack leg foot work on a PRO SERIES brand 8,000# jack? Do you happen to have the exact outer measurements of the square portion of the leg?
asked by: Luke R
Helpful Expert Reply:
The square tube of the Replacement Drop Leg # TJD-7000-FT, measures 2 inches x 2 inches.
The overall length of this part is 18-1/4 inches tall and the foot plate measures 6 inches by 8 inches. The pin holes are 5/8 of an inch and the holes measure 4 inches apart.
If your current jack leg dimension are the same then this replacement leg will work.
Product Page this Question was Asked From
Replacement Drop Leg with Foot for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Drop Leg
- 2 Inch x 2 Inch Tubing
- etrailer
more information >
Continue Researching
- Q&A: What is the Difference Between SuperCrew and SuperCab Ford Truck
- Q&A: Replacing TDE 70LP On Swing Away Tongue
- Q&A: Looking for Replacement Breakaway Battery for Old Battery Break Way Corp 081020FHon Battery
- Q&A: Comparing TruRyde 10-36 Grease and Dexter 10-63 Oil Seal
- Q&A: What is the Correct Replacement Drop Leg for My RAM 8000 Series Trailer Jack
- Q&A: Diameter of the Replacement Footplate Keeper Pin for etrailer and Ram Square, Direct Weld Jacks
- Q&A: Dimensions of MORryde Safe-T-Rail and Short Safe-T-Rail
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Maintenance Schedule
- Article: How to Install E-Track in 3 Easy Steps
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Big Truck Big RV
- Article: How to Measure for Trailer Hitch Drop
- Article: 5 Things to Know About Weight Distribution Hitches