How To Install A Toggle Switch On A Backup Camera
Updated 06/14/2024 | Published 06/04/2017
Products Featured in This Question
Question:
Im wanting to use a switch to turn on my camera for the rear or the travel trailer while moving forward down the road I have a garmin monitor and the compatible camera. Question is how do I or can I cut the camera cable and add a switch to the battery on front of trailer using the cable from camera to the switch as a 50 foot cable is way too long and inconvenient to plug in and plug out underneath the truck
asked by: Dan C
Expert Reply:
In order to control the on and off functions of your backup camera, you will need to install a toggle switch such as the Pollak Heavy-Duty Toggle Switch part # PK34571. You will then need to check the amperage of your camera to insure a 20-amp circuit is sufficient, if not we have several other toggle switches in a variety of amps I will attach for you.
In order to install this switch you will need to tap into your backup cameras power wire. This is the wire that receives a full 12 volts while activated. You can test this using our digital multimeter such as the 7-Function Digital Multimeter part # PT89ZR. This will be the wire that is ran from the camera to the battery or fuse terminal.
To install the toggle switch, you will then need to split the power wire in two attaching each end to the toggle switch. (Cutting or splicing wires on the backup camera may void your manufactures warranty)
Product Page this Question was Asked From
Pollak Medium-Duty Toggle Switch - SPST- On-Off - 12 Volt - 20 Amp - 11/16" Handle
- Accessories and Parts
- Wiring
- Switches
- Toggle Switch
- Pollak
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat - Manual Lift - 10 Speed - Smoke
- Shop: Pollak Medium-Duty Toggle Switch - SPST- On-Off - 12 Volt - 20 Amp - 11/16" Handle
- Shop: Single Rocker Switch - On/Off/On - SPDT - Black
- Shop: Single Rocker Switch - On/Off/On - Water Resistant - SPDT - Black
- Search Results: voyager camera
- Q&A: Curing Time of LaSalle Bristol XTRM Universal Non-Sag Sealant
- Shop: LaSalle Bristol XTRM Universal Self-Leveling Sealant - White - 10.1 oz - Qty 1
- Shop: Solar Powered LED Porch Light for RVs - Dusk-to-Dawn and Motion Sensors - Weatherproof - 400 Lumens
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Video: In-Depth Look at the B&W 5th Wheel to Gooseneck Pin Box
- Q&A: Looking For The Best Roof Replacement Kit For My RV
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Search Results: trailer tires and wheels
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Search Results: trailer wiring
- Search Results: trailer jack
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Search Results: trailer lights
- Search Results: trailer leaf springs
- Q&A: Availability Of Replacement Rod And Nut For Lippert Ground Control 3.0 Jack Leg
- Q&A: Recommendation to Replace Axle on 2004 TAB Tear Trailer
- Q&A: Recommended Replacement Leaf Springs For Fifth Wheel Trailer
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Q&A: Federal Requirements for Clearance Light Placement on a Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Change a Trailer Tire
Rick C.
6/13/2024
Can you use a toggle switch to control the tilt on a rear camera? The new monitor does not have the option but my rear camera does. Thanks in advance Rick