Availability Of Replacement Rod And Nut For Lippert Ground Control 3.0 Jack Leg

Question

Question:

Can I buy the replacement rod and nut for the Lippert 3.0 jack? I have mine apart and the nut is stripped out. If I could buy a replacement rod and nut I could repair this jack without buying a complete jack.

asked by: Jerry C

0

Expert Reply:

Hello Jerry, thanks for reaching out. I am sorry to say we do not offer a replacement rod and nut for the Lippert Ground Control 3.0 jacks. The only solution I can offer would be a whole new leg such as part # LC362485 which replaced the front jack leg.

I do see you ordered one of the # LC362485 legs from us a few weeks ago. Is the nut stripped on the new jack leg? Or are you needing another one?

expert reply by: Jesse M

0

Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
(click to enlarge)

Jerry C.

11/12/2025

The leg I ordered works great, the one I removed that was bad would be the one stripped. The rod and nut would fix this leg and I would have a spare jack for future use. Thanks

Jesse M.

11/12/2025

@JerryC Ok gotcha! Yes sadly we just don't offer any replacement parts for the jack leg itself. You might try reaching out directly to Lippert to see if they can provide that part. They might give you the same answer I did though, that the only replacement part is the leg itself. Doesn't hurt to ask.

Answer 1

Hey Patrick, thanks for reaching out. Yes, the Replacement Front Jack Leg #LC362485 should work for your 2021 Open Range 314RLS with the Lippert Ground Control 3.0 system. Since your weld stop “bump outs” measure 17-1/2" apart, that matches the…

view full answer...

Answer 2

It sure is Wesley. The Replacement Front Jack item #LC362485 is exact what you will need for the 6 point Lippert Ground Control 3.0 Leveling System item #LC675817. The Replacement Front Jack item #LC362485 can be used as a replacement for either the…

view full answer...

Answer 3

The distance between the insides of the weld stops on the jack leg #LC362485 is 17-1/2 inches and the outer tube diameter is 2-1/2 inch by 2-1/2 inch.

view full answer...

Answer 4

Yes, we do offer replacement jacks for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System - 6-Point Set part #LC675817. I have attached these for you below by their location on the trailer. Rear/Middle: 24-1/2" Leg part…

view full answer...

Answer 5

For the Lippert Ground Control 3.0 system #LC358590 or #LC675817 the correct front jack replacements is the part #LC362485. This works on the front and left jacks so you'd need a quantity of two. The price is available down below at the link.…

view full answer...

Answer 6

Hey Feb, no there isn't a rebuild kit for the Replacement Jack part #LC362485. If yours is damaged only solution would be a replacement

view full answer...

Answer 7

Hey Tom, for the front jacks of your Ground Control 6 point system we have the part #LC362485 as well as the part #LC241846 that you mentioned. It sounds like you are in need of the part #LC362485 but I would recommend checking out what you have and…

view full answer...

Answer 8

For front leg replacements for the Lippert Ground Control systems we have the part #LC362485 for just the leg portion or the part #LC305340 for a leg with the foot and motor as well. These will be the same length as what you have currently.

view full answer...

Answer 9

Hey Cecil. To replace a front jack on a Lippert Ground Control 3.0 system item #LC358590 or item #LC675817 you will need the Replacement Front Jack item #LC362485. This replacement works on both the left and right sides. What happened to your front…

view full answer...

Answer 10

No, the hall effect motor does not have to be greased, but per the service manual if the jacks are down for an extended period, it is recommended to spray the exposed leveling jack tubes with lubricant every 3 months for protection. If you live in a…

view full answer...

Answer 11

Hey Brett, The 346005 part number you provided is for the control module which tells me that you have the #LC675817 on your trailer. The Replacement Lead Leg #LC305340 would be a compatible replacement for this system. If the motor and footplate are…

view full answer...

Answer 12

I did a little digging on your 2021 Grand Design Reflection 303RLS, and it appears you have the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC358590. With that being said, you'll want to use the…

view full answer...

Availability Of Replacement Rod And Nut For Lippert Ground Control 3.0 Jack Leg

Product Page this Question was Asked From

Continue Researching