Availability of a Cover to Protect the Trailer 7-Way Plug From Weather and Other Elements
Updated 04/07/2017 | Published 04/06/2017
Products Featured in This Question
Question:
do you all make a cover for a seven pin trailer plug to kept out the rain and dirt. need your help.
asked by: Louis B
0
Expert Reply:
I have found a solution for you. The Fastway Tethered 7-Way Cover, # FA82-00-3315 will tether to your 7-way trailer plug and has a rubber cap that will fit over the plug end.
The cap will keep dirt and other contaminates out of the 7-way. I also recommend using # LT37534 dielectric grease with this cap. Applying dielectric grease to the plug's pins will add extra protection from moister and dirt getting into the plug's pins.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Fastway Tethered 7-Way Trailer Connector Cover with Tether
- Accessories and Parts
- Trailer Wiring
- Wire Protection
- Connector Covers
- 7 Blade
- Fastway
more information >
Continue Researching
- Q&A: Looking for Trailer Wheel/Tire with 5 on 4-3/4 inch Bolt Pattern
- Q&A: What is Pilot Diameter of Kenda Karrier KR53 ST205/75R15 Radial Trailer Tire with Wheel
- Q&A: Looking for a Printable Wheel Bolt Pattern Template
- Q&A: Wet Bolt Kit for 2025 Keystone Coleman Light 17RX
- Q&A: Is Equal-i-zer Shank EQ90-02-4900 Same as 90-02-4325
- Q&A: How to Clean a 7-Way Trailer Wiring Connector
- Q&A: How to Stop Corrosion in The 7-Way RV Style Connector
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Raise Your Travel Trailer Height
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Measure for Trailer Hitch Drop