Dust Cap Recommendation for Ranger Trail Boat Trailer with Hub Bore of 2.326 inch Hub

Question

Question:

I got a caliper and measured the axle as you suggested. I measured 2.326inch and the closest cap at etrailer is 2.337. I figured that was the correct part but the caps dont fit either side of my axle, they wont go in close but no cigar. Is that size even made? If not etrailer, then who would carry it?

asked by: Rich W

0

Expert Reply:

We have the Bearing Buddy part # BB2328SS which is designed to fit the hub bore of 2.328 which would be the closest cap solution we have. It would be tight but it would fit.

expert reply by: Jameson C

0

Answer 1

Unfortunately I have no insight on what Ranger Trailer put on their boat trailers in 2006. All I have to go off is images I could find which looks like they use the Amber #MCL52AB or #MCL52AMB and Red #MCL52RB or #MCL52RMB. The difference is the…

view full answer...

Answer 2

You will want to use a dial caliper or micrometer to measure the inner diameter of the hub you have on your trailer to determine what size cap would be needed. Check out the picture I attached that shows this measurement being taken on a hub. I wish…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hi William, We don't currently offer Goodyear Endurance tires but you could definitely get just the wheel #AM22653 and have a local tire shop mount the tire on it.

view full answer...

Dust Cap Recommendation for Ranger Trail Boat Trailer with Hub Bore of 2.326 inch Hub

Product Page this Question was Asked From

Continue Researching