Dimension Needed to Determine if Etrailer Landing Gear RVLG-8000 Fits Trailer
Published 03/16/2017
Products Featured in This Question
Question:
How wide are the posts I have a older trailer that I am trying to out the landing gear on.
asked by: Heath
Expert Reply:
The etrailer Landing Gear Set, part # RVLG-8000 can be used to replace the landing gear set you have on your trailer most likely.
Most landing gears are interchangeable but you can take a quick measurement to make sure this works for you. The weld stops measure 15-1/2 inches inside to inside and 17-1/2 inches outside to outside.
For a landing gear with a manual crank included you can order part # RVLG-8HDL.
You can add a motor to this landing gear. You would just need part # LC142178.
Product Page this Question was Asked From
Landing Gear Set - 36-1/2" Lift - 8,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 7001 - 8000 lbs
- Manual Jack
- 36 Inch Lift
- Weld-On
- 2 Jacks
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Difference Between the Landing Gear Set RVLG-8HDL and RVLG-8000?
- Q&A: Dimensions of etrailer Brand RVLG-8HDL and RVLG-8000 Replacement 5th Wheel Landing Gear
- Q&A: Best Landing Gear Upgrade Options for 5th Wheel Trailer
- Q&A: How to Choose the Correct Replacement Landing Gear for 5th Wheel Trailer
- Q&A: Replacement Follow Landing Gear Leg for 1998 Fleetwood Savanna 5th Wheel
- Q&A: How To Install the Landing Gear Set Part # RVLG-8000
- Q&A: Replacement Landing Gear for 1998 Carriage Carri-Lite RK 732
- Article: Trailer Wiring Diagrams
- Article: Best Landing Gear
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Trailer Lighting Requirements
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide