How to Install Lippert Bolt-On Shock Mount Kit LC281255

Updated 06/24/2024 | Published 02/02/2017

Question:

Installing the Lippert Components Trailer Suspension - LC281255 I purchased from you awhile back. No installation instructions where provided. Your video is not detailed enough. Search internet but no luck. Please provide installation instructions. Thank you.

asked by: Scott T

Expert Reply:

I will be happy to explain how to install the shock kit # LC281255. In addition to the instructions below I have also included a picture of the actual instructions.

1. Raise trailer and jack up the axle to release pressure on the springs.
2. Remove old u-bolts and tie plate.
3. Install new tie plate with the longer side facing outward and torque the u-bolts to the specs in the instructions. NOTE: Do NOT reuse old components.
4. Compress the shock and make a mark on the inner shock where the outer shock stops.
5. Release compression. Measure the stroke and make a mark on the inner shock that is one half of the stroke length.
6. Measure the shock length when the shock is compressed to the halfway mark made in Step 5.
7. Lower the trailer back down onto tires and level so the equalizer(s), if equipped, are parallel to the frame and there is a full load on the springs.
8. Make a measurement perpendicular to the shock mounting lip on the tie plate that is the same distance measured in Step 6 + 2” and make a mark on the I-beam parallel to the shock mounting lip on the tie plate. NOTE: Mount shocks pointing outwards (away from the shackle kit, equalizer and/or center point) to get the best performance from the shocks. NOTE: Dry fit the shock to be sure it does not exceed a 45 degree angle or it will not function.
9. Align the bottom of the extended portion of the upper shock mounting bracket to the mark made on the I-beam in Step 8 and drill 11/32” pilot holes.
10. Use the 3/8” self-tapping bolts to secure the upper shock mounting bracket to the I-beam.
11. Remove nut, washer and rubber grommet from both sides of the shock.
12. Place the shock into the shock mounting lip on the tie plate and compress it to fit into the upper mounting bracket.
13. Apply the rubber grommet, washer, and nut (in that order) and tighten to secure the shock.
NOTE: Do NOT over-tighten. Tighten until the rubber grommet increases diameter equal to the washer.