Replacement Pin and Pipe Mount for 3K Pipe Mount Swivel Trailer Jack TJP-5002S-B
Updated 01/16/2017 | Published 01/13/2017
Products Featured in This Question
Question:
Looking for the pipe mount, weld on pipe and replacement pin for this jack. I need to have this jack have two mounting points with pins.
asked by: Jay
Helpful Expert Reply:
The replacement pin for trailer jack # TJP-5002S-B is # TJP-PN58. I used digital calipers to measure the pin on the jack as well as the openings on the pipe mounts. The pin on the jack measured 0.61 inches which is between 9/16 and 5/8.
The replacement pipe # TJP-IP916 has holes that are 0.58 inches which is also between 9/16 and 5/8. Worse case scenario a little filing may need to be done on the pipe mount.
Product Page this Question was Asked From
Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Sidewind - 15-1/2" Travel - 3K
- Trailer Jack
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Sidewind Jack
- 2001 - 3000 lbs
- Manual Jack
- 16 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Can Trailer Valet Be Used with Driver instead of Drill
- Q&A: Converting 18' Flatbed Trailer From Surge Brakes To Electric Over Hydraulic Brakes
- Q&A: Replacement 5,000 lbs Capacity Jack for a Utility Trailer
- Q&A: Is There a Powered Drive Kit for the Ram Square 2-Speed Jack
- Q&A: Can Electric Motor and Gear Box Be Replaced on Bulldog 12K Trailer Jack
- Q&A: Meaning of MTI Number On Dexter Hub and Drum Assembly
- Article: Can You Flat Tow a MINI Cooper?
- Article: Hitch Mounted Cargo Carrier Information
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Jacks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern