Recommended Landing Gear For 2005 Ragen 5th Wheel Toy Hauler
Published 12/28/2016 >
Question:
I have a 2005 Ragen 3405 5th wheel toy hauler thats had a few issues already with the drive side leg passenger side.I am done playing with this I would like to replace with a new set.Any recommendations would be great preferably a little on the higher weight rating side.The legs on the unit are most likely oems and a little clumsy to me.Any help would be greatly appreciated! Thanks
asked by: Joe F
Expert Reply:
For your 2005 Ragen 3405 5th wheel toy hauler, I recommend the Ultra-Fab Deluxe Electric Landing Gear Set - 38" Lift - 12,000 lbs, # UF17-943010. This system has dual electric jacks that raise and lower independently with a toggle switch. This offers simple and accurate leveling. Each motor has a built in clutch to prevent damage from overextension. It has large footplates for stability. I have included a picture that shows the measurements for this landing gear.
Product Page this Question was Asked From
Ultra-Fab Deluxe Electric Landing Gear Set - Weld On - 38" Lift - 12,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Landing Gear
- Steel
- 10001 lbs or More
- Electric Jack
- 38 Inch Lift
- Weld-On
- 2 Jacks
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: dexter trailer springs over~under conversion kit
- Search Results: correct track
- Search Results: morryde shackle
- Shop: MORryde Shock Absorbing Suspension Equalizers for Tandem Axle Trailers w/ 35" Wheelbase - 8K
- Shop: 6-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 26" Long
- Shop: etrailer Rust-Resistant 6-Leaf Double Eye Spring for 6K Trailer Axles - 26" Long - Dacromet
- Shop: MORryde Rubber Equalizers for Tandem Axle Trailers - 33" Wheelbase - 8K
- Shop: Utopia RV Shower Valve with D-Spud - Dual Flat Lever - Matte Black
- Shop: MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps
- Shop: MORryde ALLTREK 4000 Shock Absorbing Equalizers for Tandem Axle Trailers - 33" Wheelbase - 8K
- Q&A: Replacement Brakes and Hub/Drum Assembly for a 2006 RageN Falcon 3405 Toy Hauler
- Q&A: Is There a Difference Between The Progressive Dynamics PD1620A and Your Part # PD64FR?
- Q&A: 5th Wheel Hitch With Maximum Height for Most Trailer-to-Truck Bed Rail Clearance
- Video: B and W 5th Wheel Trailer Hitch Base Rails Kit Installation - 2015 Chevrolet Silverado 2500
- Video: Progressive Dynamics Pure Sine Wave Inverter Install - 2007 Four Winds Dutchmen Motorhome
- Shop: Suspension Enhancement
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Q&A: Wiring Requirements for Mounting Rooftop AC/Heating Unit on Race Trailer
- Q&A: Recommended Clearance Dimensions Between Truck Bed Rails and 5th Wheel Trailer
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Shop: Trailer Wiring
- Article: 5th Wheel Hitch Installation | The Ultimate DIY Guide
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Video: etrailer Easy Grease Trailer Hub and Drum Assembly Installation - 2019 Grand Design Reflection 150 F
- Q&A: Recommended Replacement Converter For A Parallax 7300 Series Power Center
- Search Results: 7 pin junction box
- Search Results: 5th wheel landing gear switch
- Search Results: 5th wheel pin box
- Video: Review of Stromberg Carlson Camper Jack - Trailer Jack - 7145-943-00
- Video: B&W Patriot 5th Wheel Trailer Hitch Base Replacement Review



