Will Draw Tite QSP Anti-Rattle Device Fit a 2007 Toyota Tacoma
Published 10/12/2016
Question:
Would this work with 2007 TOYOTA Tacoma rear hitch?
asked by: Doug
0
Expert Reply:
If the hitch you have installed on your 2007 Toyota Tacoma is the Draw Tite Hitch part # 75236 then yes the Draw-Tite QSP Trailer Hitch Silencer # 63080 will fit it and work well.
This anti-rattle device only fits Draw Tite hitches though so you would have to have the mentioned Draw Tite.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Draw-Tite QSP Trailer Hitch Silencer and Cover for 2" Hitch Receivers
- Hitch Anti-Rattle
- Non-Locking Anti-Rattle
- Manufacturer Specific
- Fits 2 Inch Hitch
- Sleeve Style
- Accessory Anti-Rattle
- Draw-Tite
more information >
Continue Researching
- Q&A: Best Anti-Rattle Device To Use With Blue Ox TrackPro WDH
- Article: Anti-Rattle Devices
- Q&A: Curt or etrailer Hitch for 2026 Honda CR-V Hybrid
- Q&A: Can TowSmart Adjustable Ball Mount be Used with Gen-Y Voyager Torsion Flex Ball Mount
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Fix a Bad Trailer Ground
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Command Center Hub for the Curt RVi Series 3 Portable Flat Tow Braking System
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Best Anti-Rattle For Towing A Trailer With A Weight Distribution System
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Recommended Trailer Hitch Receiver and Cargo Basket for 2015 Subaru Forester
- Q&A: Recommendation to Reduce Aluminum Ball Mount Wear Due to Steel Hitch Receiver