Can the LED Heavy Duty Trailer License Plate Light # LPL41CB Ground Through Mounting Hardware
Published 10/06/2016
Question:
Can this light be grounded through the mounting holes or does the ground wire have to be hooked up?
asked by: Tracey
0
Expert Reply:
The LED Heavy Duty Trailer License Plate Light # LPL41CB that you referenced is designed to ground to a ground wire circuit. You can ground it through the mounting hardware, but you would need to cut the white wire shorter and then strip it back so that you could insert the core of the wire between the mounting bracket of the light and the trailer frame.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Optronics LED Trailer License Plate Light - 5 Diodes - Chrome Plated - Clear Lens
- Trailer Lights
- License Plate Lights
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 4L x 1-3/4W Inch
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Replacement for a Tie Down 70lc Brake Actuator
- Q&A: Axle Hub That Uses Bearings JM511946 and JM205149, Race JM511910 and JM205110
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting EOH Brakes With Hydrastar Actuator Not Working With 2024 Ford F-450
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Q&A: How Much Do the Rock Tamers Heavy-Duty, Adjustable Mud Flap System for 2" Hitches Weigh?
- Q&A: Replacement Actuator For Older Tie Down 70LC
- Q&A: Replacement Hub and Brake Assembly for AL-KO 8490
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Replace or Install an RV Roof Vent
- Article: Double-Eye Trailer Suspension System Review
- Article: 7 Common Questions Everyone Has About Trailer Tires