Dimension of Flange Width for Redline Spare Tire Carrier
Published 09/14/2016
Question:
It appears both flanges where you would weld is about 1.00 correct?
asked by: Numa
0
Expert Reply:
Yes, the flange will measure 1-3/32 inches (1.09375) on each side. I have attached a few dimensional diagrams to this page for you to better see.
I have also linked the above mentioned product to this page fro your convenience.
expert reply by:
Jackie C
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Spare Tire Carrier - Horse Trailer
- Spare Tire Mount
- Gooseneck Mount
- Weld-On
- 5-Bolt
- 6-Bolt
- 8-Bolt
- Trailer
- Standard Finish
- Redline
more information >
Continue Researching
- Q&A: Replacement Swivel Jack w/a Wheel for a Boat Trailer
- Q&A: Erickson ATV E Track Tie-Downs For ATV With Backing Plates
- Q&A: Is There A Good Quality Aluminum Jack For Boat Trailer That Has Swivel Jack On Side Of Frame?
- Q&A: What Is The Difference Between Kenda AM10234 And KE88KV Tires?
- Q&A: Do These Kendra Tires with Americana Wheels Come with Center Caps or Lug Nuts
- Q&A: Options For Mounting A Spare Tire Under The Tongue Of A Trailer
- Q&A: Do I Have To use All Bolt Holes of E-Track ATV Tie Down Kit
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 4 Common Myths About RV Solar Power
- Article: Dealer Spotlight - Croft Trailer and Hitches
- Article: The 5 Best Trailer Drop Hitches You Can Buy