What is the Distance Between the Mounting Holes on Sealed, Mini LED Trailer Light # MCL13A2B
Updated 10/20/2010 | Published 10/19/2010
Products Featured in This Question
Question:
what is the hole spacing on this light.
asked by: Troy
0
Expert Reply:
The center to center distance between the 2 mounting holes on the Sealed, Mini LED Side Marker, Clearance or Identification Light, 2 Wire, 2 Diode - Amber, # MCL13A2B, is 1-15/16 inches.
You might also be interested in Snap-on, Polished Chrome Ring for MCL13 Series LED Lights, # A13C2B, or Foam Gasket for MCL13 Series LED Lights - Black, # A13G2B.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Optronics LED Mini Clearance or Side Marker Trailer Light - Submersible - 2 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 2-1/2L x 1-1/16W Inch
- Amber
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Top Wind Swivel Jack that Fits a 2-1/2" Diameter Snap Ring Mount
- Q&A: Mounting Hole Dimensions of CE Smith 12" and 13" Plastic Single Axle Fenders
- Q&A: Is There Prep Work Needed to Install Rubber Door/Hatch Seal for RV and Trailers # SR98ZR
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Q&A: How is Horse Trailer Side Pad # HTP60BK Usually Attached
- Q&A: Replacing TDE 70LP On Swing Away Tongue
- Q&A: Do Thinline LED Clearance and Side Marker Lights Come With Bracket and Wiring
- Q&A: Dimensions of Fastway Replacement Round Spring Bar Arms for Fastway e2 Weight Distribution Systems
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 7 Common Questions Everyone Has About Trailer Tires