Wiring Pop and Lock tailgate Lock PAL8600 in a 2008 Honda Ridgeline
Updated 08/24/2016 | Published 08/23/2016 >
Question:
Greetings, I am interested in how to run the wiring for this lock. I really appreciate the video you have for the manual lock, it clarified a lot, but I woudl like to figure out how difficult it is to run the wires to a power source before deciding on which to buy. 2008 HONDA RIDGELINE 4WD V6 CREW CAB 3.5L RT. Thank you!!
asked by: Stephen
Expert Reply:
Below are the wiring instructions for Pop and Lock tailgate lock for your 2008 Honda Ridgeline:
Wiring (there are other ways to run the wiring this is one way) - Snake the short wiring cable up the tailgate through the driver side drain hole and connect it to the bullet connectors of the power unit. Secure with cable ties to pre-vent the wire from getting pinched or in the way of the latch rods. Connect the other end to the long wiring cable.
Locate this connector under the truck so that it is accessible for tailgate removal. Run the long wiring cable along the factory wire harness to the engine compartment securing it with cable ties. Snake it into the driver’s compartment using the rubber grommet in the firewall that the factory wire harness run through from the fuse box.
Remove the driver side kick panel and run the wire down into the driver side kick panel. The lock and unlock wires are located in the fuse box under the kick panel. The yellow with a black stripe (lock) and the yellow with a green stripe (unlock) wires are in the small green plug that is located at the bottom front side of the fuse box.
Use the two blue wire taps to connect to theses two wires. Connect the male terminal ends of the long wire harness to the blue tap connectors. Test the operation of the lock (if the tailgate lock works in the opposite direction as the door locks un connect the male terminal and switch the wires that they were plugged into). Secure all the wiring and replace the kick panel.
Product Page this Question was Asked From
Pop & Lock Custom Tailgate Lock - Power - Black
- Tailgate Locks
- Lock Only
- Power Lock
- Keyed Unique
- Vehicle Specific
- Black
- Pop and Lock
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Truck Tailgate Lock
- Shop: Pop & Lock Custom Tailgate Lock - Manual - Black
- Shop: Pop & Lock Custom Tailgate Lock - Manual - Silver
- Shop: Pop & Lock Custom Tailgate Lock - Power - Black
- Video: Pop & Lock Custom Tailgate Lock Review
- Video: Pop and Lock Custom Tailgate Lock Manufacturer Demo
- Shop: Pop & Lock Custom Tailgate Lock - Manual - White
- Shop: Tonneau Cover
- Video: Installation: Pop & Lock Custom Tailgate Lock on a 2012 Honda Ridgeline
- Q&A: Do the Pop and Lock Tailgate Handles for a 2010 Honda Ridgeline Lock Both Handles
- Q&A: How to Wire Pop & Lock Tailgate on Honda Ridgeline Using Wiring Behind B-Pillar
- Q&A: Can the Pop & Lock # PAL8600 for Honda Ridgeline Be Installed to Truck Lock Wiring?
- Q&A: Tailgate Lock Recommendation for 2018 Honda Ridgeline
- Shop: BAKFlip G2 Hard Tonneau Cover - Folding - Aluminum
- Shop: Pop & Lock Power Upgrade Kit - Power - Black
- Shop: Pop & Lock Custom Tailgate Lock - Power Lock and Manual Lock - Black
- Q&A: Installation of Pop & Lock Manual Tailgate Lock for 2013 Honda Ridgeline
- Q&A: Tonneau Cover and Tailgate Lock Recommendation for a Honda Ridgeline with Factory Backup Camera
- Video: Complete Breakdown of the Pop and Lock Power Upgrade Kit
- Video: Ultimate Overview of the Pop & Lock Custom Tailgate Lock
- Video: Installation: Pop and Lock Custom Tailgate Lock on a 2017 Honda Ridgeline
- Video: BAKFlip G2 Hard Tonneau Cover Review BAK26328
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer tires and wheels
- Shop: Suspension Enhancement

