How to Power Supplemental Braking on a Vehicle that Requires Battery to Be Disconnected
Updated 08/23/2016 | Published 08/22/2016
Products Featured in This Question
Question:
I Have set-up my 2016 Yukon Denial to flat tow with Blue Ox products ,Road Master Even Brake and a negative battery post disconnect switch. As the Yukon manual states you must disconnect the negative battery terminal before flat towing. As I do that is cuts all power off in the vechile leaving no power to run the Even Brake. Any ideas on how to get around this problem? Thanks
asked by: Tom M
Expert Reply:
We have just what you need as this is a fairly common situation. What you need is the part # RM-9332. This attaches to the battery and allows you an outlet for an accessory like your Even Brake part # RM-9400 to have power.
You will also need the part # DW05705-1 to connect to the battery post as well.
Product Page this Question was Asked From
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: rm792
- Shop: Roadmaster Hy-Power Diodes (Qty 2)
- Shop: Roadmaster Single Park Light Diode
- Q&A: Recommended Flat Tow Setup for Blue Ox Tow Bar on 2008 Honda CR-V
- Q&A: How Many Diodes Needed to Install Roadmaster Second Vehicle Kit
- Q&A: Flat Tow Set Up For a 2026 Jeep Wrangler Rubicon
- Q&A: Will Curt RVibrake Shadow 2 Fit 2026 Ford Maverick Hybrid
- Q&A: Parts Needed to Flat Tow 2026 Chevrolet Trax
- Q&A: Electrical Parts Needed To Flat Tow a 2026 Ford Expedition Max Platinum
- Q&A: What Else Do I Need to Flat Tow My 2025 Jeep Wrangler Sahara?
- Article: Trailer Wiring Diagrams
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2020 Jeep Wrangler
- Article: Must-Have Flat Towing Components