Availability of LED Back-Up Lamp for 2-1/2 Inch Rough Opening
Published 07/23/2016
Products Featured in This Question
Question:
I need 2 LED backup lights that will go in a 2 1/2inch hole and can not seem to find the right part number. Please advise
asked by: Troye S
0
Expert Reply:
If you can very slightly enlarge the hole so it's 2-5/16 inches in diameter, I have a grommet mount lamp that will work great for you. The # UCL50CB LED lamp would use the # A54GB grommet and the # A46PB wiring pigtail.
The lamp isn't considered a back-up lamp, but unless the vehicle in question is a commercial vehicle that's subject to DOT inspections, it'll work great for you.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Uni-Lite LED Clearance and Side Marker Light w Grommet - Submersible - 2 Diodes - Clear Lens - Amber
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 3/4 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Recommended Trailer Hitch for 1999 Ford F-350 Super Duty
- Q&A: comparing Curt Class III and IV Trailer Hitches for a 2001 Ford F-150
- Q&A: Replacing Trailer End 4-Pole Connector That Has 8 Wires
- Q&A: Wiring for Clearance and Turn Signal Functions with Clear Lens 2 Wire LED Light
- Q&A: Torque Specs for the TorkLift Front Camper Tie-Downs TLD2141
- Q&A: Replacement Roof Vent Lid for Fan-Tastic RV Roof Vent
- Q&A: What Is The Amp Draw For The Peterson LED Clearance/Side Marker/Third Brake Light PET75PV?
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Stability Control for Heavy Duty Vehicles