Replacing the Anti-Rattle Nut in a Yakima HoldUp or DryDock Shank

Updated 07/14/2016 | Published 07/13/2016

Products Featured in This Question

Replacement Hitch Bolt for Yakima HoldUp 2, OnRamp, and BigHorn Bike Racks and DryDock Canoe Carrier

(312)

$13.33

Replacement Hitch Hardware for Yakima HoldUp Bike Racks for 2" Hitches

(126)

$14.75

Question:

I did not receive instructions with this kit. It is not apparent how to get the old nut plastic housing out. Help

asked by: Paul B

Expert Reply:

It sounds like you are actually talking about part # 8890260 with the pin and anti-rattle nut and housing. On the outside of the rack shank close to the end you will see 2 holes with part of the black plastic nut housing in them. These hold the nut in. You will need to push them in while pulling on the hook in the at the same time to remove the old assembly. When putting in the new one be sure to have the hook end facing towards the shank opening. Once the retention pieces fit into the holes installation is complete.

expert reply by: Michael H