Can the Bulb in Sealed, 6-1/2 Inch Oval Trailer Stop, Turn and Tail Light, # ST70RB be Replaced
Updated 08/24/2010 | Published 08/23/2010
Question:
how to replace bulb in tail light
asked by: Robert
0
Expert Reply:
Because Sealed, 6-1/2 Inch Oval Trailer Stop, Turn and Tail Light, # ST70RB, is a sealed tail light, the bulb cannot be replaced. You would need to replace the whole tail light if the bulb needs to be replaced.
expert reply by:
Reno H
0
Product Page this Question was Asked From
Optronics Trailer Tail Light - Stop, Turn, Tail - Submersible - Incandescent - Oval - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Oval
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 6-1/2L x 2-1/4W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Locking Hitch Pin For Swagman Bike Rack
- Q&A: How Far Apart Are The Bolt Holes On etrailer Scissor Jacks e56VV ?
- Q&A: Will Inno Roof Rack for 2016 Kia Optima Allow Water to Leak in to Vehicle
- Q&A: Availability Of 2" Long 1/2" Wheel Stud With 0.56" Spline
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Hardware To Install Curt C13379 Class III Hitch on 2011 Ford Taurus
- Q&A: Looking For Replacement 7-Way Plug With Double Prong Design
- Q&A: Leaf Spring Bushings Closest to 1-1/4 Inch Outer Diameter
- Article: Slipper Spring Trailer Suspension System Review
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Can You Flat Tow a 2025 Cadillac Escalade?
- Article: Trailer Maintenance Schedule