Setting Up Lippert Ground Control 3.0 After Installing Replacement Control Module
Updated 04/05/2016 | Published 04/01/2016
Products Featured in This Question
Question:
how do you reprogram remote. Wont communicate with camper
asked by: Rich C
Expert Reply:
I called my contact at Lippert about reprogramming the remote for your Ground Control 3.0, part # LC358590 when you install the replacement control module, part # LC304136.
In the service manual you will need to follow the instructions for Homing Jacks and Zero Point Calibration on page 6. They told me that the first thing you need to do before following these steps is to lower the inner leg on the front landing gear legs but make sure you have no more than 5 holes showing. Then you follow the instructions as stated above.
Product Page this Question was Asked From
Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Controllers
- Control Module
- Lippert
more information >
Continue Researching
- Q&A: How To Test for Bad Controller on Lippert Ground Control 3.0 Electric Leveling System
- Q&A: Replacement Control Module for Lippert Ground Control 304135
- Q&A: Can A Demco Auto Slide 5th Wheel Hitch From A Ford Be Transferred Over To A Chevy Truck?
- Q&A: Troubleshooting a Lippert Level-Best Leveling System that Suddenly Stopped Working
- Q&A: Air Force One Air Jumper Kit For Spartan K2 Chassis.
- Q&A: Replacement Brake Assemblies and Hub/Drum for Airstream with Nev-R-Lube Hub/Drums
- Q&A: Replacement Control Module for Lippert Ground Control 3.0
- Article: How to Set the Right PSI for Your Air Bags
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: The Best 5th Wheel Hitches
- Article: No Missteps Here: Best Camper and RV Steps (2022)
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?