Timbren Axle-Less Suspension for Use with 30 Inch Tires and 6 on 5-1/2 Bolt Pattern Hubs
Updated 03/21/2016 | Published 03/18/2016
Products Featured in This Question
Question:
Hello, Im very interested in your system for a long bed Toyota utility trailer project. I would like to know if the 2,000 lb rated kit can be fitted with 6 lug hubs to match my Lancruiser, electric brakes, and 4 to accommodate 30 to 31-inch tires. Can this kit include obtainable replacement bearings and seals, and what would the approximate weight of this entire set up amount to?
asked by: Jeff N
Expert Reply:
You can use 6 on 5-1/2 bolt pattern hub and drum assemblies on the Timbren Axle-Less system # ASR2KHDS03. For a hub and drum assembly that will work I recommend # AKHD-655-35-EZ-K. You can then add electric brake assembly # AKEBRK-35L for the left side and # AKEBRK-35R for the right side.
Replacement parts are readily available for the hub and drum assemblies and the brakes. The Timbren system shouldn't ever need any part replaced but if it does we can take care of you there, too.
Each brake assembly weighs about 8 pounds; the hub assemblies are about 23 pounds each, and the Timbren system is approximately 105 pounds for a total of approximately 167 pounds. Err on the side of caution and call it 170 pounds.
I have also included a link to the wheels and tire and wheel combos we have that use the 6 on 5-1/2 bolt pattern.
Product Page this Question was Asked From
Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle w/ 4" Lift - 4 Bolt - 2K
- Trailer Axles
- Rubber Spring Suspension
- Standard Grade
- No Hubs
- 2000 lbs
- Spindles Only
- Universal Fit
- Lift - 4 Inch
- Timbren
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What is the Difference Between Load Range B and C Trailer Tires
- Shop: Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle w/ 4" Lift - 4 Bolt - 2.2K
- Q&A: Replacement Foot Plate for a Lippert Jack 359278
- Q&A: Recommended Timbren Axle-Less System with 5 on 5 Bolt Pattern Hubs for Overland Trailer
- Q&A: Is There a 3,500 Lb Idler Hub with Hub Bore Less Than 64MM
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Comparing Timbren Axle-Less 2K Trailer Suspension Systems with 4" Lift
- Q&A: Timbren Axle-Less Trailer Suspension Compatibility with Jeep 5 on 5 Bolt Pattern
- Q&A: How to Add a 7-Way Connector and Brake Controller to a 2024 Subaru Outback Wilderness
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Tire Sizing
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Raise Your Travel Trailer Height
- Article: How to Measure Your Trailer Wheel Bolt Pattern