Brake Flange Mounting Bolt Recommendation for Kodiak Disk Brake Kit K2R526D
Updated 03/02/2016 | Published 03/01/2016
Products Featured in This Question
Question:
Brake flange configuration: 5 bolt Are the flange bolts 10 total needed provided with this brake kit K2R526D ? If not what is the size needed ? These brakes will be installed with a new Dexter Torsion axle. Stainless recommended ? Thanks
asked by: John B
Expert Reply:
The brake flange mounting bolts are not included with the Kodiak Disc Brake Kit # K2R526D that you referenced. If you need bolts you would want the part # 7-5 for the bolt, part # 38LW for the washer and part # 38N for the nut.
These aren't stainless, but they will still work fine. If you wanted to go with stainless you would have to source them at a hardware store.
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 12" Rotor - 6 on 5-1/2 - Dacromet - 5,200 lbs to 6,000 lbs
- Trailer Brakes
- Disc Brakes
- Marine Grade
- 6 on 5-1/2 Inch
- Rotor
- 5200 lbs Axle
- 6000 lbs Axle
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- Kodiak
more information >
Continue Researching
- Q&A: Is There Lock that Comes with etrailer Spare Tire Mount for Hitch # e98ZR
- Q&A: Replacement 6-on-5-1/2 Idler Hub Kit to Replace Hub 82655
- Q&A: Spindle Recommendation for Trailer Hub with Bearing Dimensions of 1.25 and 1.75 inch
- Q&A: Differences Between Combined Hub & Rotor and Separate Hub & Rotor Brakes
- Q&A: Availability of Rebuild Kit for Titan Model 10 Actuator
- Q&A: Replacement For TDE LP75 Disc Brake Actuator
- Q&A: How to Find Correct Bearing Kit for a 2004 Four Winns Boat Trailer with 5,200 Lb Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: The Best Boat Bumpers