Grommet to Mount 4-5/16 Inch Diameter Round Taillight in 4-1/2 Inch Opening
Updated 02/10/2016 | Published 02/09/2016
Products Featured in This Question
Question:
I dont see a listing for a grommet for the 4 1/2 recessed lights for optronics or any for that matter. What do i need to order. My trailer has 4.5 inch holes.
asked by: Vern
Expert Reply:
We have exactly what you're looking for. To mount the Optronics # STL13RB LED Trailer Taillight in a 4-1/2 inch rough opening, you'll need the Optronics # A45GB grommet.
When you install the grommet, make sure it's fully inserted into the opening, then install the lamp. The wiring pigtail is sold separately as part # A47PB for a right angle plug or # A45PB for a straight plug.
Product Page this Question was Asked From
Optronics LED Trailer Light - Brake, Tail, Turn - Submersible - Round - Red
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement Electric Trailer Brakes For A Hayes 8K 4 Bolt Axle
- Q&A: Mounting Hole Pattern For Dexter Electric Trailer Brake Assembly # K23-532-00 & K23-533-00
- Q&A: Square Drop Leg Stabilizer Jack Tube and Pin Hole Diameters
- Q&A: Replacement Recommendation for an Atwood 85736 Actuator
- Q&A: Can I Use Shims or Washers to Close the Gap Between Trailer Tongue and Demco Hydraulic Actuator
- Q&A: Are There Shims for a Trailer Axle Castle Nut
- Q&A: What is Max Safe Tire Temperature
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Performance Chips and Modules
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers