SH On Prodigy Brake Controller But Trailer Brakes Work Fine with Different Tow Vehicle
Published 07/22/2015
Question:
I recently bought a new trailer, pulled it with 2008 F250 integrated brake controller and the brakes work fine. When hooked to my RV with a Prodigy controller I get an SH code.
asked by: Timothy D
Expert Reply:
The SH error on the Prodigy series of brake controllers indicates that the controller is sensing a short. Since it worked fine with your truck the likely culprit is a dirty or corroded trailer connector on the RV.
Make sure that the RV side and trailer side connectors are clean and free of corrosion inside where the wires attach and on the pins. Be sure to fix or replace any questionable wires as well.
If this does not solve the problem you can test the brake controller using the help articles I have linked for you.
Product Page this Question was Asked From
Replacement Magnet Kit for 12" Electric Trailer Brake Assemblies - 5,200 lbs to 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- 5200 - 7000 lbs
- Brake Magnets
- 12 Inch
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: How To Tell Apart 5,200 lb, 6,000 lb and 7,000 Axles
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Q&A: How to Know When Trailer Brake Magnets are Worn Out and Need Replacing
- Article: Trailer Wiring Diagrams
- Q&A: Troubleshooting Weak Trailer Brakes That Won't Lock Up with Override Lever of Controller Slid
- Q&A: Parts Needed to Add Lithium Batteries to 2020 nuCamp T@B 320S
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: What is Proper Way to Torque Trailer Axle Spindle Nut
- Q&A: Solution for Lost Breakaway Pin for Trailer Breakaway System
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Article: Most Popular Wheel Bearings
- Article: Trailer Maintenance Schedule
- Article: Trailer Lighting Requirements