Looking for a Trailer License Plate Light that is Submersible

Question

Question:

Looking to replace my License Plate Light with an LED Light that is Submersible. Existing light is a Truck-Lite Model 17 that is not submersible. The bracket that is there should work for any light, it about 6inch wide x 3inch tall. What are my Options?

asked by: Blair F

0

Expert Reply:

All of the license plate lights we have that are listed as submersible are incandescent, not LED. We have Peterson light # M439K and Optronics light # LP97CB. Though the lights are submersible you will need to make sure the wiring connections are water-tight by using something like liquid electrical tape, # SWC50122.

expert reply by: Michael H

0

Answer 1

Yes, we do have a couple of idler hubs that fit the item #L44649 inner and outer bearings on your Venture boat trailer. They come in two different lug pattern sizes and are designed specifically for boat trailers. I couldn't get any information…

view full answer...

Answer 2

I wasn't able to find anything in regard to a replacement part for your TDE 11029C hub assembly, but if you can pull your hub and either look for bearing/grease seal parts numbers or measure the different locations on your spindle then I can see…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 8

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 12

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Looking for a Trailer License Plate Light that is Submersible

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching