Troubleshooting Five Wires that Turn into 4-Flat Connector
Updated 05/13/2015 | Published 05/11/2015 >
Products Featured in This Question
Question:
I have to replace the vehicle-to-trailer connector on my Grand Cherokee Laredo 98. It has 5 wires that turns into a 4-flat connector. Colors are: Red Green Yellow Brown White I have a Vehicle wiring harness from your company- it only has Gr/Br/Ye/White going into the 4-flat. No red. How do I make this work? Can I simply attatch the green? Connected everything but the green and red.
asked by: James
Expert Reply:
Sounds like you want to replace the vehicle side 4-way on your Jeep. If that is the case, you will want to use a circuit tester like part # PTW2993 and test the function of each wire.
I have attached a couple of helpful articles about wiring and how to troubleshoot.
Product Page this Question was Asked From
16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot
- Wiring
- Wire
- Bonded Wire
- 4 Wire
- 16 Gauge
- Deka
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Roadmaster Parts For Flat Towing 2023 Ford Edge ST
- Q&A: Testing The Dexter Electric Over Hydraulic Brake Actuator
- Q&A: What Wire Colors do I Need to Attach for Installing Roadmaster Smart Diodes in 2024 Sierra 1500?
- Article: Trailer Lighting Requirements
- Q&A: Can I Use an Adapter to Plug the 30 Amp ActiveStart Plug-In Soft Start to a 50 Amp Plug?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: How do Safety Chains Attach and Remove from Trailer Frame
- Q&A: Parts Needed to Flat Tow a 2017 Subaru Crosstrek Behind an RV
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: How To Power A Third Brake Light With Diode Wiring While Flat Towing
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: 7 Common Questions Everyone Has About Trailer Tires




