Best Way to Drill Holes Through the Curt Gooseneck Flat Plate Part # C65500

Updated 04/30/2015 | Published 04/29/2015

Question:

After I get the folding rails in place and spaced properly whats the best way to drill through the flat plat and hit the existing holes in the rails?

asked by: Jim E

Expert Reply:

The best way to drill through the Curt gooseneck flat plate # C65500 is using a standard drill and drill bit. When drilling go slow and steady. It's a soft steel so you won't have any issues drilling a hole. When you're drilling through metal, it's a good idea to drill the holes in two or three stages. Begin with a small diameter bit and use the subsequent bits to gradually enlarge the hole

I would use the pre-drilled holes in the rails to mark the locations on the flat plate.

I included a picture for you to look at too.

expert reply by: Chris B