Replacement Taillights, Wiring and 7-Way Connector for Car Hauler
Published 03/05/2015 >
Products Featured in This Question
Question:
Need All new lights, wiring...EVERYTHING. for a 16foot car hauler with brakes on both axles. The round openings for the Rear brake lights are 4.5inch . The round openings for the rear and side running lights is 2.75. I want to USE LED lights. Not sure if your or any current model lights will work. Your sizing for the lights doesnt mention the rubber gasket the holds the lights in. So... what will work????
asked by: James
Expert Reply:
To fit the round 4-1/2 inch holes on your trailer for the rear brake lights you could use the # STL42RB as this will fit in that hole. For a pigtail harness you would also need # A45PB.
For the side clearance lights you would need to enlarge the holes to 3 inch in diameter, use the # A55GB as a grommet and then use # MCL59AB for the lights and # A46PB as a wiring harness.
For a replacement 7-way with 8 feet of wire for running new wire everywhere you would want the part # H20046. You would want to route the wires from there to a junction box like part # 38656; from there you will use the # 16-4B-1 for the wiring of the lights and then for the brake assemblies you would want to use the double bonded wire # 10-2-1 sold by the foot to route 10 gauge wire to the assemblies.
Product Page this Question was Asked From
Optronics LED Trailer Tail Light - Stop, Turn, Tail - Submersible - 10 Diodes - Round - Red Lens
- Trailer Lights
- Tail Lights
- Brake/Tail/Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4 Inch Diameter
- Red
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: al91
- Search Results: license plates and frames
- Search Results: breakaway chain
- Search Results: license plate bracket with light
- Search Results: dexter trailer axles
- Shop: Dexter Surge Brake Actuator - Disc - Elec Lockout - 2" Ball - Zinc - 7.5K - 3" x 4"
- Video: Optronics Black PVC Trailer Light Grommet Review and Installation
- Video: Hands-On with the Optronics LED Trailer Tail Light
- Video: Review of CE Smith Trailer Safety Chains - Safety Chains - CES82QR
- Shop: Tie Down Class III Hitch Cable - 3' Long
- Q&A: Replacement Surge Brake Actuator For Trailer W/ Older Swing Away Actuator For Disc Brakes
- Q&A: What Size Trailer Tongue Does Dexter Actuator # DX29FR Fit
- Q&A: Comparing Dexter Surge Brake Actuators DX29FR And DX89FR
- Q&A: Parts Needed to Install the 6-1/2" Oval LumenX LED Trailer Tail Light
- Q&A: Length of Dexter Brake Actuator with Manual Lockout
- Q&A: Difference Between Dexter DX7.5L A-60 Brake Actuators For Disc Brakes
- Q&A: Measurements for Dexter DX7.5L A-60 Brake Actuator
- Shop: Right Angle 3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead
- Shop: TecNiq Stop Tail Turn Light - 6" - Oval - Pigtail - Surface Mount
- Shop: Grommet for Optronics A91, AL82, AL90, AL91, or AL191 Series Trailer Lights - Black PVC
- Shop: 14 Gauge, 4 Conductor Jacketed Wire - Per Foot
- Shop: Buyers Products 3/8" x 35" Class 4 Trailer Safety Chain w/ Clevis Hook - 30 Proof
- Video: Checking Out the Kodiak Disc Brake Kit-K2R526DKG
- Video: All You Need to Know About the Kodiak Disc Brakes
- Search Results: trailer wire
- Search Results: 4 pin trailer wiring
- Video: Complete Breakdown of the Optronics LED Trailer Tail Light-STL42RB
- Video: Optronics LED Trailer Tail Light Feature Review
- Shop: Brake Controller




