Mounting Hole Dimensions for Universal Hand Winch Right Angle Bracket DL24110
Updated 03/31/2010 | Published 03/29/2010
Question:
Wnat are the center to center dimensions of the holes?
asked by: John S
0
Expert Reply:
I got a schematic for the # DL24410 right angle bracket from my contact at Dutton-Lainson, and the center to center hole measurements for the smaller holes are 3-1/4 inches side to side, or 2-1/8 inches front to back.
The outside openings of the oval holes are in line with the centers of the smaller holes.
The bracket itself measures 5-7/16 inches wide, and both sides are 5 inches long from the center of the bend.
expert reply by:
Sarah L
0
Product Page this Question was Asked From
Universal Hand Winch Right Angle Mounting Bracket for Hand Winches by Dutton-Lainson
- Accessories and Parts
- Trailer Winch
- Mounting Hardware
- Brackets
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Troubleshooting Ultra-Fab Phoenix Electric Tongue Jack That Won't Extend or Retract
- Q&A: etrailer Winch for Boat Trailer that Tows Ski Nautique 206
- Q&A: Will the Fulton Brake Winch 143100 Fit the Universal Right Angle Mounting Bracket 24110
- Q&A: Base Dimensions and Mounting Hole Location of MaxxTow MaxxHaul Hand Winch # MT50156
- Article: How to Measure a Trailer Axle
- Q&A: Troubleshooting A Greystone RV Range Hood That Only Blinks
- Article: How to Wire an Electric Winch
- Q&A: Mounting a Winch on a Snowmobile Trailer Tongue or Ball Mount
- Q&A: Dutton-Lainson Hand Winch Compatibility With Drill Drive Socket Adapter
- Article: Hand Winches
- Article: Determining Trailer Tongue Weight