Hole Dimensions of the TorkLift Rubber Camper Bumpers TLA7001
Published 02/18/2015
Question:
Could you please, provide missing dimensions: counterbored holes thru, cbore, cbore depth, center to center distance. Thank you.
asked by: Gene
0
Expert Reply:
I forwarded your question to my contact at Torklift and he informed me that the holes in the # TLA7001 are 4 5/8” apart. The small holes that pass all the way through are 7/16” and the counter sinking hole is 1 1/8”.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Continue Researching
- Q&A: Looking For Camper Tie Downs For My 2025 Chevy Silverado 1500 Trailboss 6.5ft Bed
- Q&A: What Does The Reese 36041 RV Hitch Fit?
- Q&A: Is There a 5th Wheel Hitch & Underbed Rails For 2023 Ford F-350 Long Bed
- Q&A: Replacement Breakaway Switch Solution for Brake Buddy II Supplemental Braking System
- Q&A: Replacement Truck Bed Camper Bumpers
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: 4-Step Guide to Installing RV Solar Power
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: Electric Motors, Circuit Board and Remote For Upgrading HappiJac Manual Jacks On Camper Prewired
- Q&A: Torklift Camper Tie Down for 2024 Chevy Silverado 1500 6.5' Bed Factory Hitch
- Article: Trailer Wiring Diagrams
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: How to Mount a Truck Bed Camper
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer