Videos
for Nissan Frontier Owners
Help Articles
for Nissan Frontier Owners
Expert Answers
for Nissan Frontier Owners
Hey Ed! Yes, if you want the Timbren SES #TTORTUN4L to have a smaller gap and engage sooner, or be engaged all the time, you can add the Spacer Kit for Timbren Suspension Enhancement System #T93AV. Is this for hauling your commercial mower and…
view full answer...Hey Ben, the total height of the etrailer jack part #e34RV when fully retracted is 16-1/2 inches. Would that fit in the area you have between the fender and rear supports?
view full answer...Hello again Ed! You probably ended up outside our fitguide with some of the Timbren the parts you were looking at. The Timbren SES severe service kit is designed for constant loads like a truck bed camper or salt spreader. Regardless, a severe…
view full answer...Hey Josh, the dimension for both jacks that you are looking for is the bracket height. This is the distance from the center of the jack's mounting bracket down to the ground when extended/retracted. On the shorter part #e34RV the bracket height…
view full answer...Hey Ed, welcome back! Looking at your picture there you have plenty of room for the Roadmaster Quiet Hitch #RM-061 which is what I recommend. The Quiet Hitch is a high quality anti-rattle that will hold up nicely over time. If you're still…
view full answer...Hey Edward! You can loosen and retighten the Roadmaster Quiet Hitch for 2" Trailer Hitches #RM-061 as many times as you need to. This isn't designed to be a permanent installation so you can pull it when you're swapping/removing a ball…
view full answer...To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…
view full answer...For the etrailer D-Ring Tie Down Anchor #RRING-Q6000 you will need to use the Backing Plate #BP05. This will increase surface area for the bolts used to attach the anchor to your floor giving it additional support. I included a video of the…
view full answer...Yes, per the installation instructions, your 2014 Nissan Pathfinder with the Controller Area Network, or CAN Bus system, it is recommended by the manufacturer that you use the 30-amp circuit breaker kit #331-CBK30-EB. This, along with your Redarc…
view full answer...Hey Jim, thanks for reaching out. The swivel mount that comes with the #e34RV jack uses M12 bolts. I grabbed one of the mounts from our warehouse to check, and it looks like it comes with M12 bolts, nuts and lock washers, so you shouldn't need to…
view full answer...First lets start with a hitch for your 2022 Nissan Frontier. For that I'd recommend the etrailer part #e98869 which has great towing capacities and is mostly hidden. Then for trailer wiring you would need to start with the 7-way kit part #118266…
view full answer...The lip is supposed to be there. It appears to be a way to allow the bracket to set more level than what the frame of the truck allows since it is angled and not parallel to the ground.
view full answer...



































