2023 Ford F-150 Headache Rack

Hey Chris, the overall height of the Aries AdvantEdge Headache Rack #AA88VB that you referenced is 26-1/2 inches. It's not difficult to remove but wasn't designed for getting removed and installed super easily.…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

Hi David; the BringIt SwitchBack SOLO Down Tailgate Camera #BR75ZR can be used without a tailgate. You will need to mount the tilt sensor so the system thinks the tailgate is open for this to work. I would also cap off the unused connector with…

To add a gooseneck hitch to your 2024 GMC Sierra 2500 with a 6-3/4' bed, I recommend the B&W Custom Underbed Installation Kit item #BWGNRK1020. It has a massive 30,000 lbs capacity and fits both the 6-3/4' and…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

The biggest pro to using one valve stem to maintain air pressure in an air bag kit is that you always know that both bags will have an equal amount of pressure in them. If you have an application where equal pressure on both sides is always the…

The Custer 40-LED Light Bar w/ Controller Box - Magnet/Suction Cup Mount - 23" Long #STR-40-S will work well for your Hurst and funeral services. The magnets will not come into play with a fiberglass roof, but the suction cups will keep…

For the Edge CS2 Evolution Diesel Tuner you will need to enter the programming menu. You will turn on your vehicle without starting it. Then use the Menu button to open the main menu and scroll down with the arrow to the Programming on the screen.…

The B&W Custom Headache Rack w/ LED Brake, Turn, Tail Lights #BWPUCP7500WA uses bonded 4 pole wire to make the connections, however most of the new Fords have a "smart" tow plug, which means that it is looking for voltage to…

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory…

Since you already have a factory 4-way flat on your 1996 Ford F-350 you will need the Adapter 4-Pole to 7-Pole #37185. This will plug into your factory 4-way and the rest of the wiring will have to be spliced into your factory wiring as I do not…