2005 Headache Rack

Hi Kipp; the Blue Ox SwayPro Weight Distribution w/ Sway Control for 2-1/2" Hitch #BLU54TR will work well with this setup. The tongue weight range for this system is 1,000-1,500 lbs. With batteries and propane added to the trailer tongue you…

Hey Elvin, I wasn't able to find any bracket kit for that light, but I was able to find the Ultra-Thin LED Strobe Light #3378892202 for amber and white lights, #3378892200 for just amber, or #3378892201 for just white lights, which can be mounted…

The install of the Aries AdvantEdge Bull Bar #AA89FB does require removing the factory tow hooks.

Hello Joseph, yes there is! What you are looking for is the Anti-Rattle Hitch Lock and Cable Lock for 2" Hitch Mounted Bike Racks #e88RV. This will work with the Benton Bike Rack #B54VR, as well as the #B94FR and #B54FR so that the bike and rack…

Good afternoon Nathan, that's a great question! You can use the etrailer Anti-Rattle Hitch Collar for 2" Hitch Receivers #e38FV with a 3" to 2" reducer adapter like Buyers Products 3" to 2" Receiver Tube Adapter…

Hi Mary, Do you leave the camper in the bed most of the time or does this truck spend a good chunk of time driving around without the camper? The SumoSprings Solo Custom Helper Springs #SSR-211-54 would be a great option if you leave the camper in…

Hello Dan, thanks for reaching out. The Firestone #F2550 for the 1999 Ford F-250 2WD will be compatible with the B&W Turnoverball gooseneck hitch. The brackets are designed specifically to be compatible with in-bed hitches like the B&W, so if…

The bed width didn't change between the year models so you shouldn't have an issue with fitment on the 2012 model. If you have the Aries Classic Headache Rack #AA111000 that you were looking at then I can confirm that this will fit the 2012…

For a 2003 Chevy Silverado 2500 6-1/2 foot bed we have the part # AA111000 which is a confirmed fit from Aries but the part number you mentioned will not work as it is designed for newer trucks. Another option similar in appearance that is a fit is…

Do you have a crew cab or a regular cab? Torklift is really particular with their fits but with that last bit of info I should be able to see what solution would work.

To have a support, we normally use a second set of hands because that is the safest and easiest option. When another set of hands is not available, an option is to use the Ultra-Fab Slide-Out Supports for Motor Homes - 21" to 37" - Qty 2…

You're not "required" to use a jack and jack stands when installing the Curt #C13269 but when performing the installation without an additional set of hands it's never a bad idea to have something that you can use to hold the hitch…