Truck Grilles Specs:
Features:
Add to the curb appeal of your vehicle with these easy-to-install accents. Insert pieces snap into place in your Jeep's factory grille openings. Chromed plastic is durable, corrosion resistant, and stylish.
More Information >Truck Grilles Specs:
Features:
Add to the curb appeal of your vehicle with this easy-to-install, steel mesh grille insert. Single-piece insert installs behind your Jeep's factory grille shell. Black powder coated steel is durable, corrosion resistant, and stylish.
More Information >Videos
for Truck Grilles
Help Articles
for Truck Grilles
Expert Answers
for Truck Grilles
The towing capacity of the 2003 Chevrolet Avalanche 1500 with 5.3L V8 and 4.10 rear axle is 8100-lbs. For a 7600-lb GVWR travel trailer the resulting 500-lb safety margin is adequate/low-ish. With a trailer that weighs substantially more than the tow…
view full answer...Hey Kevin, welcome back! You are correct, since you have ParkSense on your 2026 Rubicon the #RM-152 is not the correct wiring kit. What you need instead is the Roadmaster Smart Diode Kit for Variable Voltage LED Tail Lights #RM47ZR. This will get…
view full answer...Hey William, We do have a great option for an airbag kit for your 2026 Ford F450. I recommend the Airlift #AL88399 airbags, these offer a 5,000lb load leveling capacity with no drill installation. Depending on what you are towing these also are…
view full answer...I'll start by saying that when your camper is pre-wired for use with a Go Power Solar, all of the hard wiring is done for you; all you'll need to do is connect your Go Power Solar panels to the installed cable entry plate and the solar panels…
view full answer...Westin MAX Winch Mounting Tray #46-21245 is a confirmed fit for your 2006 GMC Sierra 2500 HD and it mounts in front of the factory bumper. The linked photo, taken from the install instructions which I've sent to you, shows the finished appearance…
view full answer...The Center Section #C-52 for the Curt Overbed, Folding Ball Gooseneck Trailer Hitch #C61341-52 is very close to the measurements you provided. I have included an image with the measurements for this as the front to back mounting holes are 9-3/4"…
view full answer...Since gooseneck and 5th wheel hitch brackets need to match with the hitches themselves, even if your Atwood folding gooseneck hitch fit the Curt rails I couldn't recommend doing so because they have never been tested together. For a similar…
view full answer...I reached out to my contact at Demco and he said that depending on the year, there was a gear adjustment bolt on the cab side of the base of the older Hijacker models. He also said some of the slide bar heads had an adjustment bolt there as well for…
view full answer...Yes, the Westin Platinum Series Oval Nerf Bars #21-2315 comes with all the included hardware for a quick and easy bolt-on installation to your 2005 Dodge Ram 1500 quad cab.
view full answer...No, it does not John. The only power cord available for the Furrion Vision S monitor is the item #C-FOS07TAPK-006 you have. The only solution I have is for you to install the 12 Volt Outlet Kit, 20 amps item #RM-9332, which will provide you with a…
view full answer...Hey David, thanks for reaching out. That is a slick camper. Your 2017 Airstream flying cloud uses a #11 Dexter axle. It uses a #25580 (1.75" inner diameter) inner bearing and #M67048 (1.25" inner diameter) outer bearing. We can provide…
view full answer...Yes, the Edge CTS3 Programmer part #EP39YR that you referenced would fit and work well on your 2011 Chevy Silverado with a 6.0 liter V8. It also will work with the basic modifications you mentioned as well. As long as you don't go beyond what you…
view full answer...
Filters
