1969 Oldsmobile 442 6.6L V8 Engine Exhaust

Yes, the Solera Slide Topper part #LCV000168106 is the correct fit for your flange width of 90-1/2 inches. This specific model has a box width range of 86 to 91-3/4 inches which is perfect for your width listed.

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave…

According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement…

I recommend to use the Solera 16-1/2' Slider part #LCV000435661 which matches the boxes width exactly so you will not have side overhang like we normally recommend but it is the biggest slide topper available to fit the…

We have toppers that'll work for 2 of your 3 sliders. For your 12 foot 9-1/2 slide, use #LCV000168109 which is designed for slides measuring between 152-157 inches wide. The longest topper we offer is for slides 188-193-3/4…

If you check out the picture I attached you can see that the roller and slide out awning assembly of the Solera RV Slide-Out Awning #LCV000435661 actually will sit below the awning rail so your setup having a tight clearance between the rail and…

Please note the attached instructions. The Lippert Anti-Billowing Kit for Solera Slide Topper Awnings, #LC78FR should be installed on the end of the awning that is closest to the front of the unit. 1. Make sure awning is fully retracted. 2. Place…

According to Solara (Lippert), the correct number of turns to set the proper tension of their slide toppers like #LCV000163285 is between 12 to 16 turns, so I'd consider 14 to be a pretty good happy medium.

You sure can! You'll just need to know the brand and model of your slide out awning. For example the Solera Slide out awning #LCV000168109 uses replacement fabric #LCV000442075. We only sell fabric for Solera awnings at this time…

The best way you can determine if your 2021 Ford F-150 has LED or Incandescent lights is to call the dealer with your VIN number and they should be able to tell you. If your vehicle has LED lights, you can use the Roadmaster Universal Wiring Kit…

For vehicles where it's nearly impossible to find a dedicated stop light circuit the Roadmaster Universal Stop Light Switch Kit #RM-751000 is a great solution. Basically it gets power from your battery and has it's own…

The 2022 Ford F-150 (Non-Hybrid) requires special diodes for the flat-tow wiring harness. If you're not using these special diodes then you could run into issues like you described. The correct ones for this vehicle are the…