1962 Jeep M-38A1 Jeep Doors

Yes, we do! It is the Hopkins Custom Tail Light Wiring Kit item #HM39VR. This will give you a plug and play set up to control your 2020 Jeep Wrangler's lights with your RV.

Geoff, the wheel bearings for the Yakima Rack N Roll is not available for replacement, unfortunately. To replace the bearings you'd need to replace the entire wheel with the Replacement Wheels for Yakima Rack and Roll Trailer #8880157, which…

On the Jeep Wrangler and Jeep Truck models the steering wheel does not actually lock with the ignition in the off position, it just has a loss of power steering-which is likely what you're experiencing. Jeep removed the steering wheel lock from…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Yes, you can bypass the door switch on your Lippert steps. You can do this by connecting the two wires together. If your steps operate then you know the switch is bad and can replace it with the Replacement Door Switch #LC301694 if you have the…

I don't have a way to verify what D-ring size you have on your Smittybilt Stryker but if what you have is the 7/8 inch size you would need the part #BX88357 or if they are 1 inch you'd want the part #BX88358. Both of these are compatible with…

Both the two products you referenced #B5178615 and #B5460115 will fit your 1992 Jeep Wrangler and are compatible with each other. The windows of the #B5460115 are tinted, but the part #B5178615 does not have any tint.

We have what you need! Here are the parts: - Replacement Tire for Wheel on Yakima Rack and Roll Trailers - Qty 1 #Y8880282 - Replacement Inner Tube for Wheel on Yakima Rack and Roll Trailers - Qty 1 #Y8880283 - Kickstand for Yakima Rack and Roll…

To add a hitch to your 2024 Jeep Gladiator, I recommend the etrailer item #e67AR. This class III hitch bolts to your Jeep with included hardware. It fits all models of the 2024 Gladiator. The etrailer item #e67AR has a 5,000 lbs towing capacity and a…

The Replacement 2 inch Hitch Adapter, part #853-7489, you asked about is an adapter, that Thule says will fit TH9028, TH9029, TH9030, TH9031 and TH934XTR bike carriers. They have the threaded hole in the shank that aligns with the hole on the…

I will be happy to explain how to install the shock kit #LC281281. In addition to the instructions below I have also included a picture of the actual instructions. 1. Raise trailer and jack up the axle to release pressure on the springs. 2. Remove…