Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…
Hey Justin, welcome back! The 136" measurement on the Parking Brake Kit #T2385201 is the overall length of the rear cable. It runs back roughly half that length on each side from where it runs through that central bracket. What kind of trailer…
Hey Daryl, I took a look at that PoleStar jack you mentioned and it looks like it has 2" diameter tubing. A good replacement jack foot for that jack will be the #LC165253. Designed to fit 3,500lb jacks with 2" tubing this will be a solid…
Welcome back Jordan! I have an alternative for you but we do not have any Ram 7k jacks that can be bolted on. Just welded like item #TJD-7000S and pipe mount like item #TJDP-7000S-B options. For a 7,000 lbs capacity square jack that can be bolted on,…
Hello Shawn, Thanks so much for including the pictures, they really help. I have a solid solution for you, and it’s actually not going to be going with higher rated leaf springs. The best fix here is installing the Dexter Trailer Springs Over-Under…
Hello Chris, Thanks so much for writing in and a double thank you for including the full brake assembly part number. That is incredibly helpful! Since you have the Kodiak Disc Brake Kit 11.35" Rotor #120 Spindle 12K ALKO #K2HR12A11-120DW, you…
Hi Frank, While we can get you a brake controller for your 2020 Chevy Colorado, there isn't a plug-in option and harness because the truck doesn't have a plug under the dash. That said, the wires are already run to the cab, so it isn't…
I recommend mounting the Low Profile LED Flood Light #OPT64FR on the upper frame of your trailer. This light is 2" tall and will broadcast the light down at a 45 degree angle. The housings are made of aluminum to help protect the light from…
Hey Dave, thanks for the pictures! Based on what you have and what you are looking for the Tie Down Spare Tire Mount part #TD66FR that you referenced would be a great option. This is very similar to what you have now so it would do a great job.
Hey Kevin! Are you replacing it because you're upgrading to lithium or is there a specific reason you don't like it? WFCO products are pretty nice, and the new WFCO Auto-Detect RV Converter Charger #WF38FR would be the direct replacement.…
Hey Greg, I drew up a little diagram showing the hole spacing for the TecNiq Industrial LED Scene Light #TN43XR. If you need any other measurements let me know and I'd be happy to help.
Yes we do, I attached a picture that shows the installation instructions for the Timbren Front Suspension Enhancement System #TGMFK15CA that you referenced.
Filters
