throw blankets - RV Travel Map

Good question! Can you close the hatch of the vehicle the CVT Timber Creek Annex #RG35ZV is attached to? Yes. However, it should be noted that the hatch is actually acting as a roof support, so some of the roof will not necessarily cave in, but it…

I spoke to Demco about the Demco Autoslide Locking Plate for Lippert Rhino Pin Boxes part #DM76FR, the side plates are supposed to be angled as that's what provides the clamping force. I would just make sure you have the bolts torqued fully to…

You will want a slider hitch like you mentioned to prevent the nose of your trailer from hitting the cab of your 2019 Ford F-350 since you have a short bed truck. The slider hitch allows the pivot point to move back and give you the needed clearance.…

The Maxtrax Flat Rack Mount for MKII Recovery Boards will work just fine with the Yakima LockNLoad platform rack. These mounts will just slide into the top channels on the LockNLoad using the included t-bolts.

Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…

The JR Products Automatic Changeover 2-Stage Propane Regulator #37207-30395 should be set to give you 11" WC straight from the factory. The pressure will still be the same so there won't be an issue with the new regulator having a higher BTU…

We only carry the black version of the DeeZee toolbox you mentioned part #DZ8560WB. We have a smaller aluminum version part #DZ8546 but it's only 8 feet of cubic storage. This might be enough for you though since you didn't mention the amount…

I spoke with my contact at DeeZee about your 2000 Chevrolet Silverado Truck With the stepside. We do not have a crossover toolbox that would fit your truck but we do have other options. I recommend the DeeZee Toolbox, part #DZ8546. this is a chest…

Hey Walter. You can send whatever you want me to look at directly to the email address you receive this response from.

Yes, the Curt Trailer Hitch Receiver #C76WR fits all models of the 2023 Ford Bronco. That includes your Big Bend trim. It has a simple bolt-on installation and comes with a limited lifetime warranty. If you plan on towing, you will also need wiring…

Yes, it does. The Curt Hitch 13493 or our part number item #C76WR is confirmed to fit the 2024 Ford Bronco. This hitch is custom fit and bolts to your Bronco with included hardware. This is a class III hitch with a 2" receiver. It has a 3,500…

The only hose we have with the right connector for the B&B Nautilus P4 RV Water Control Panel item #BM54GR is the B&B 15' Coil Water Hose with 1/4" Quick Connect - Blue item #BM67MR.