Trailer Tie Down Anchors - RackEm

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

Hi Wayne, I went out to the warehouse and measured the Caliber D-Ring Anchor Kit part #CA89VT for you. The plate dimensions are 4" long by 3 3/4" wide and the inner diameter of the ring is 1 1/4" and outer diameter is 2 1/4". What…

Hey George! Assuming you're looking for a complete kit, the Erickson ATV E Track Tie-Down Kit w/ Ratchet Straps and Wheel Chocks #EM98CV you were looking at covers just about everything. This is compatible with 10" - 30" diameter tires,…

We do not sell a complete kit but we do sell a backing plate that is compatible with the Square D-Ring Tie-Down Anchor item #ABS69FR. It is the Backing Plate for Brophy Recessed D-Ring Tie-Down Anchor item #BP05.

Hey Dave, thanks for reaching out! The Erickson Round D-Ring Tie-Down Anchor #EM59110 has a capacity of 1,200 lbs and is not going to be strong enough to cinch down your Polaris RZR securely. You need the CargoSmart Anti-Rattle D-Ring Tie-Down Anchor…

Welcome back Jordan! I have an alternative for you but we do not have any Ram 7k jacks that can be bolted on. Just welded like item #TJD-7000S and pipe mount like item #TJDP-7000S-B options. For a 7,000 lbs capacity square jack that can be bolted on,…

A keen observation indeed, Brett. The mounting hole spacing on the Square D-Ring Tie-Down Anchor #ABS69FR is 3" horizontally and 3-1/4" vertically. I edited a picture for you to help illustrate.

I would measure the distance between the center of one bolt hole to the center of the bolt hole adjacent to it, and not the diameter. If the distance is: 2-5/8" - the bolt pattern is 5 on 4-1/2 2-3/4" - the bolt pattern is 5 on 4-3/4…

Hey Mike, thanks for reaching out. No. The RV Designer On/Off Wall Switch with Bezel and Plate #RD43VR is only available with a standard, non-illuminated rocker switch. If you're looking for the same functionality with an illuminated switch, RV…

Hey Corry, you would basically want to mock up the Terran Industries Tandem-Axle Hanger Kit #TX85VJ with the 26-5/8 inch springs that you have and have the springs temporarily mounted in the hanger and the equalizers to get the correct dimensions to…

Hey Brian! The BTBRV Trailer Jack Foot Scale #BTBRV014 is not designed to live on your trailer jack permanently. If you're traveling or storing your trailer you definitely want to remove it and replace it with your standard foot. If you're at…

I did some research and found that the Erickson O-Track Cargo Control System like part #EM59133 is very similar to the L-Track systems you referenced. The Erickson O-Track is 18 inches long and includes 2 Spring-loaded O-ring clips and mounting…