Hey Eric, the Curt Multi-Fit Ball Kit w/ 4" Offset for Chevy/Ford/GMC/Nissan Underbed Gooseneck Hitch #C68ZV is not going to work with your Ram, unfortunately. This one is only going to work for select YMM (Year…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Yes, it will! The 5" Offset Gen-Y Hitch Gooseneck Trailer Hitch item #GY43XR is specially designed to work with the Ford factory puck system. It will push the connection point for the gooseball and your cattle…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That…

The shortest gooseneck ball we have for the 2024 Chevy puck system is the Reese Elite Series Pop-In Ball #RP23FR. This is going to be very similar to the Curt ball you mentioned. I have included some dimensions of the Reese ball below. From the top…

The puck feet on the Gen-Y Hitch Gooseneck Trailer Hitch for Dodge Ram OEM Puck Systems #GY83XR is just to help stabilize the ball mount and does not lock into place in the puck. The locking mechanism on top will lock the shank into the gooseneck…

Yes, it will! The 5" Offset Gen-Y Hitch Gooseneck Trailer Hitch item #GY83XR is specially designed to work with the Ram factory puck system. It will push the connection point for the gooseball and your trailer back…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely…

Yes, since the Gen-Y Hitch Gooseneck Trailer Hitch for Ford OEM Puck Systems #GY43XR has a 5" offset it will place the pin weight 2-1/2" behind the current center of your gooseneck…

Reese has a gooseneck ball that fits the OEM pucks of your 2020 GMC Sierra 3500 with the part #RP23FR but this doesn't have any rise built into it. The ball you mentioned does not fit your truck.

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to…

If you were to use the 4 inch offset ball #BWGNXA4085 the pin weight on the ball will not be changed. What will change is where the weight is carried on the truck. Using the offset ball will put more weight 4 inches back from the center of the…