For your bolt pattern of 4 on 4 inch the largest wheel and tire size we have is 175/80D13 like the part #AM3S030 which has an overall diameter of 24 inches. This will be right at 6 inches taller than your current tires.
Yes, you can absolutely drill holes in your trailer tongue to install the 10,000 lb capacity Buyers Products Straight Tongue Trailer Coupler #3370091560. This is a pretty common occurrence due to the various bolt hole patterns of straight tongue…
For a pedestal mount LED light that would work great on your trailer to light up the ramp I would recommend the Opti-Brite LED Work Light part #TLL50FB. I attached an install video for you to check that shows the light being used in a very similar…
The Air Lift 1000 Air Helper Springs for Coil Springs part #AL60769 which are a fit for a 2013 Chevrolet Suburban do not require the coil springs to be removed for installation. I will admit though, there are times were I thought it would be faster…
Hey Stephany, thanks for getting in touch. The only difference between the etrailer Electric Trailer Jack #e23ZV and the #e55ZV is the weight capacity. The #e23ZV has a 3,500 lb capacity, while the #e55ZV has a 5,000 lb capacity. Because of the…
Hey Vernon, The best way to reduce tongue weight if you have to much is using a weight distribution system like #C95MJ. This system is going to evenly distribute the weight between the trailer and the towing vehicle taking stress off of the rear axle…
Trailer tires typically don't wear out before they need to be replaced due to age. In nearly every situation a tire will need replacing when it hits 6 years of age unless you have a suspension issue that causes a wear issue.
Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…
I do have a great option for you but a Reese system is not going to be the best choice in this case. You will need to box the trailer frame where the weight distribution brackets will go by having steel plates welded on. What you can use is an…
Hey Jack, If you're talking about a transition plate then you'll want the etrailer Enclosed Trailer Transition Plate #e32JR. This can be installed on either end of the ramp to help make the transition onto easier or at the hinge of the ramp…
The cover I recommend for your 28 foot enclosed cargo trailer is the Adco Polypropylene Storage Lot RV Cover #290-74845. This cover is made of a heavy-duty, 4-layer fabric that protects against UV rays, dirt, wind, and snow and is a breathable…
Filters
