Hi Darrin! The MORryde RV Cargo Slide Tray - 90" x 23" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR78RV can clear a lip up to 1.57 inches, so call it 1-1/2 inches to be safe. If you need it to be higher, we do also have the Height…
Hey Bob, thanks for reaching out, and good question. For that setup, as long as the tray is properly secured in the portion that is touching the floor, it will be just fine. It might be a bit more difficult to install since you can't secure the…
Hey Ethan. From the mounting point of your RV to the top of the carpeted base is going to be 2.31" on the MORryde RV Cargo Slide Tray item #MR78RV. The bottom of the tray sits 1.57" above the mounting point on your RV and the wooden base is…
Hi Chuck! The MORryde RV Cargo Slide Tray - 72" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR67FR sits 1.6 inches above the floor you mount it on. If you want or need it to be a bit higher off the floor, you can also grab the…
Hey Tim. The 48" x 23" measurement is the entire MORryde RV Cargo Slide Tray item #MR63ZV. The inside tray dimensions are 46-1/4" long x 19-7/8" wide. The MORryde RV Cargo Slide Tray item #MR63ZV has a 800 lbs capacity and slides…
Hey Richard, I wish there was a way to lock out the MORryde sliding cargo trays like the part #MR76FR in the extended position but that's just not a feature they have. They can lock in the retracted position but not extended. Are you loading…
Good question, Dave. The easiest way is to match the RVpaws kit to your jack leg or leveling system. For example, there are specific kits for the brands and lineups out there: Standard 2" round jack leg = #RV57FR Standard 2" square jack leg…
Hello Clint, thanks for getting in touch. With the Phoenix Electric Trailer Jack #UF38-944040, generally when the unit beeps and does not function properly, it is due to a low voltage situation. The first thing to do will be to check your battery and…
You can go with a listed 29" model of the MORryde RV Cargo Sliding Tray as its actual width is 28-3/4". Please note the attached image showing dimensions of width. We have the #MR69FR that is 90" in length by 29" wide and has a 2…
Hey Jeff! For a replacement I recommend the etrailer Electric Trailer Jack #e23ZV. This is a direct replacement with the same 18" lift and 3,500 lb capacity as your FIC-ETJ3500-LP10. If you want something with a little more power we have the…
Hey Arthur, The dimensions I'm seeing for a 3500watt Predator Generator show it being 22.8" L x 17.3" W x 20" T so if you're wanting it to sit with the 17.3" side facing out the closest fit would be the MORryde RV Cargo…
While there is no visual guide available to determine the sizing for the MORryde sliding cargo trays like the #MR38FR, it really depends on the height, length, and depth of your RV compartments opening. The #MR38FR that you were looking at, for…
Very fast service. Shipped out an hour after I ordered it.Thanks!!
Robert
Westfeild, PA
RV Cargo Slides for 48 inch long and 39 inch wide bays
Dial in a solid fit with 48 inch long and 39 inch wide trays matched to your storage space. A 39" wide by 48" long tray fit a 40" x 50" cargo bay, leaving enough room to comfortably install this tray. Look for ball bearing slides for a smooth, easy operation and a carpeted bottom to keep items from sliding around.
A 39" slide in a 40" bay leaves space to comfortably install it. Verify the opening is a true 40" and check for door frames or trim that could reduce width. Measure the full path so the slide can extend and retract smoothly.
Yes, a 48" slide suits a 50" deep compartment. It leaves a little room so the tray can operate without hitting the back wall. Confirm the depth at floor level and check for obstructions like wiring or lips that could limit travel.
Choose slides that utilize ball bearing slides for smooth, easy operation. If you want to help keep items from sliding around, look for a carpeted bottom. After install, cycle the tray to confirm full travel without binding or rubbing.
Yes, a 39" wide, 48" long slide fits well in a 40" x 50" bay. The 39" width gives you enough room to comfortably install it. The 48" length works within a 50" depth without crowding the compartment.
Filters
